cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
hsnchahrour
Newbie
Newbie
231 Views
Registered: ‎11-09-2020

FPGA xczu11eg does not boot

I have a problem with the FPGA configuration. I am trying to boot it using the JTAG but without succeeding. The power sequence is correct. Anyone can help me detect the error ?image.png

power Status OFF, cannot program PL. Check that POR_B signal is LOW or BOOT mode is JTAG.

0 Kudos
Reply
2 Replies
hj
Moderator
Moderator
199 Views
Registered: ‎06-05-2013

Please make sure you are keeping the device in JTAG boot mode i.e 0000.
-------------------------------------------------------------------------------------
For more information please refer to configuration resources https://forums.xilinx.com/t5/FPGA-Configuration/Configuration-Resources/m-p/753763/highlight/true#M5891
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Reply
hsnchahrour
Newbie
Newbie
179 Views
Registered: ‎11-09-2020

The FPGA is in the JTAG boot mode and still can't configure it

0 Kudos
Reply