cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
crisilc
Contributor
Contributor
518 Views
Registered: ‎03-15-2018

Kintex Ultrascale Config with MX25U51245G

Hi 

I have a custom FPGA(Kintex Ultrascale) board with Macronix MX25U51245G as NOR for storing configuration bitstream. As per vivado, this device is a supporting part. I tried to erase config flash through vivado2018.2 and it fails. Vivado complains that it's unable to read the device id. From the log, MFG ID is received as 0.

Any clue about failure? Any suggestions for debugging?

Thanks,

Crisil

 

0 Kudos
5 Replies
iguo
Xilinx Employee
Xilinx Employee
437 Views
Registered: ‎08-10-2008

Have you tried with a new version of Tool? The support may be added later.

------------------------------------------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
---------------------------------------------------------------------------------------------------------
0 Kudos
crisilc
Contributor
Contributor
419 Views
Registered: ‎03-15-2018

Yes. I have tested with 2020.2

0 Kudos
whxiao
Adventurer
Adventurer
248 Views
Registered: ‎10-31-2017

Do you resolved this problem? I encountered the same question.

0 Kudos
crisilc
Contributor
Contributor
223 Views
Registered: ‎03-15-2018

Macronix has 2 devices starting with the part number "MX25U51245G". 

Vivado works with only one of them which has the same part number as MX25U51245G

 

0 Kudos
whxiao
Adventurer
Adventurer
203 Views
Registered: ‎10-31-2017

My part number is MX25U51245GZ4I54 and vivado cannot detect this part

0 Kudos