cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
valekiri
Visitor
Visitor
5,699 Views
Registered: ‎08-07-2015

SEM Core support for Zynq Ultrascale + family.

Jump to solution

I was wondering when and if Zynq Ultrascale + family will support use of the SEM core. It seems Kintex Ultrascale + and Virtex Ultrascale + are supported and Zynq are not.

 

Thanks

0 Kudos
1 Solution

Accepted Solutions
valekiri
Visitor
Visitor
10,284 Views
Registered: ‎08-07-2015

Thank you Krishna. I suppose I need to wait a bit for that.

Val

View solution in original post

0 Kudos
4 Replies
balkris
Xilinx Employee
Xilinx Employee
5,678 Views
Registered: ‎08-01-2008
yes it supported . check list of supported devices
http://www.xilinx.com/products/intellectual-property/sem.html
Thanks and Regards
Balkrishan
--------------------------------------------------------------------------------------------
Please mark the post as an answer "Accept as solution" in case it helped resolve your query.
Give kudos in case a post in case it guided to the solution.
0 Kudos
valekiri
Visitor
Visitor
5,637 Views
Registered: ‎08-07-2015

Hello Balkrishnan,

 

I have just noticed that in the manual 3.1 it says "In 2016.1, only KU9P is supported in pre-production capacity and has been verified in hardware."

 

I downloaded and tried out with 2016.2, however I got the same result, where if KU9P is selected it is shown in the list. However, any other Ultrascale + device causes the SEM core to dissapear from the list.

 

Any workaround is appreciated.

 

Thanks,

Val

0 Kudos
kkn
Moderator
Moderator
5,544 Views
Registered: ‎01-15-2008

Hi Val,

 

SEM IP support for zynq ultrascale+ MPSOC is in the roadmap and you will see in the coming versions made available

 

--Krishna

0 Kudos
valekiri
Visitor
Visitor
10,285 Views
Registered: ‎08-07-2015

Thank you Krishna. I suppose I need to wait a bit for that.

Val

View solution in original post

0 Kudos