cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
171 Views
Registered: ‎01-16-2019

Set Smartlynq Frequency

Jump to solution

Is it possible to set the default JTAG Frequency through the Smartlynq config.ini file? I am aware that the smartlynq defaults to 40MHz, but it would be ideal for our setup to default at 15MHz. This way if power ever goes out, the device will default to the desired frequency.

I am hoping to add something similar to line below into the config.ini file.

set jtag-frequency 15000000

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
147 Views
Registered: ‎02-09-2017

Re: Set Smartlynq Frequency

Jump to solution

Hi @christopherjd,

 

Yes, you can set any of the hw_server configuration params in the .ini file. To set the default frequency, just add set jtag-default-frequency 15000000 to the .ini.

Thank you,

Andre Guerrero

Product Applications Engineer

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

1 Reply
Highlighted
Moderator
Moderator
148 Views
Registered: ‎02-09-2017

Re: Set Smartlynq Frequency

Jump to solution

Hi @christopherjd,

 

Yes, you can set any of the hw_server configuration params in the .ini file. To set the default frequency, just add set jtag-default-frequency 15000000 to the .ini.

Thank you,

Andre Guerrero

Product Applications Engineer

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post