11-03-2015 10:23 AM
I get this error: WARNING:iMPACT:923 - Can not find cable, check cable setup !
Windows 7 Home Premium
I'm using iMPACT 14.7 and a VIRTEX-II PRO XC2VP30,
USB embedded JTAG CONFIG,
Two weeks whit this error.
11-03-2015 10:26 AM
Have you tried solutions mentioned at below link
11-03-2015 10:27 AM
Please go through http://www.xilinx.com/support/answers/30184.html
11-03-2015 10:33 AM
I tried the six solutions; can I use a regular usb cable? or it is a special cable?
11-03-2015 10:57 AM
You can use regular USB cable nothing special.
11-04-2015 10:02 AM
Can you share the snapshot of device manger?
If the drivers are installed properly you will see Jungo drivers in the device manager as shown below.
Are you able to see the Jungo drivers in the device manager?
Generally these type of issues will appear if the drivers are not installed properly.
Can you try uninstalling and installing the drivers from the command prompt?
Please follow the below steps.
Please make sure that the cable is not connected while performing these steps and you need to have admin privileges.
11-04-2015 10:07 AM
I see Jungo drivers and programming cables.
I reinstall the drivers already.
thanks a lot.
11-04-2015 10:17 AM
09-17-2016 11:52 AM
I ran into the same issue and have been working on resolving it. Going to iMpact 10.1 is not a solution for me.