cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
686 Views
Registered: ‎09-03-2017

vivado 2017.1 BPI Flash programming error

Hi,

I am using PC28F128P33B Flash with Artix 7 devices. I am getting unable to query common flash interface error.

Support for this BPI flash for Artix 7 devices was not there till Vivado 2016.1.

Does Viado 2017.1 supports PC28F128P33B Flash?

Regards,

B Sandeep.

0 Kudos
5 Replies
Highlighted
Xilinx Employee
Xilinx Employee
641 Views
Registered: ‎06-06-2018

Hi @sandeepcrl,

Yes, PC28F128P33B is supported in Vivado 2017.1. 

Please refer page318 of UG908.

Regards,

Deepak D N

----------------------------------------------------------------------------------------------

Please reply or give kudo or mark it as an Accepted Solution.

---------------------------------------------------------------------------------------------

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------
0 Kudos
Highlighted
Visitor
Visitor
628 Views
Registered: ‎09-03-2017

I am getting unable to query common flash interface error while programming flash from Artix 7.
0 Kudos
Highlighted
Moderator
Moderator
619 Views
Registered: ‎01-15-2008

can you provide the complete vivado programmer log file for the issue you are facing.

can you recheck your BPI interface signals are proper by referring to UG470 for the bpi configuration section

0 Kudos
Highlighted
Xilinx Employee
Xilinx Employee
617 Views
Registered: ‎06-06-2018

Hi @sandeepcrl,

 

Please share the complete error log file.

 

The Indirect programming core sends a CFI query to the flash before carrying out any info. You will see this message when this fails. Try the following -

 

Reduce cable speed(Try reducing it to 3MHz or lower)

Check schematic connections

Check Flash is powered correctly

 

These are common causes of this issue.

Regards,

Deepak D N

------------------------------------------------------------------------------------------------

Please reply or Give kudo or Mark it as an Accepted Solution.

------------------------------------------------------------------------------------------------

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------
0 Kudos
Highlighted
Visitor
Visitor
599 Views
Registered: ‎09-03-2017

Mfg ID : 0 Memory Type : 0 Memory Capacity : 0 Device ID 1 : 0 Device ID 2 : 0
Performing Erase Operation...
Erase Operation failed.
ERROR: [Labtools 27-3161] Flash Programming Unsuccessful
ERROR: [Common 17-39] 'program_hw_cfgmem' failed due to earlier errors.

Reduced cable speed didn't help.

Schematic connections are ok.
Power supply to the Flash is stable.
0 Kudos