cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Participant
Participant
7,231 Views
Registered: ‎05-05-2016

I hate to ask but what does the colored dot mean next to the IP in the source window?

Jump to solution

I have no doubt this is covered in detail in one of the very thourough user guides.  I just can't figure out which one!  I've been searching for longer than I care to admit.  I have found IP icon definitions but the green dot wasn't covered.  To make matters worse, I think I've actually seen where this topic is explained but can't seem to recall where I saw it or how I found it.

 

ARRRGGGG

 

Thanks

0 Kudos
Reply
1 Solution

Accepted Solutions
Participant
Participant
13,846 Views
Registered: ‎05-05-2016

OH MY GOSH! ARRRG 

 

I finally found it.... , RIGHT after I hit the submit button to the forum!

 

Its in the User Guide 632 page 63.

"Local files that you copy into the project directory have

a green dot next to the file name in the Sources view."

 

Thanks for the assist syedz. Im sure you would have directed me right to it given the chance.

 

View solution in original post

2 Replies
Moderator
Moderator
7,228 Views
Registered: ‎01-16-2013

@waidcsuf,

 

Can you please share the snapshot showing the colored dot which you are talking about?

You should be able to find the answer in the below UG:

http://www.xilinx.com/support/documentation/sw_manuals/xilinx2016_1/ug893-vivado-ide.pdf 

 

--Syed

---------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.

Did you check our new quick reference timing closure guide (UG1292)?
---------------------------------------------------------------------------------------------
0 Kudos
Reply
Participant
Participant
13,847 Views
Registered: ‎05-05-2016

OH MY GOSH! ARRRG 

 

I finally found it.... , RIGHT after I hit the submit button to the forum!

 

Its in the User Guide 632 page 63.

"Local files that you copy into the project directory have

a green dot next to the file name in the Sources view."

 

Thanks for the assist syedz. Im sure you would have directed me right to it given the chance.

 

View solution in original post