10-28-2020 01:05 AM
Hi All,
I have an unknown compiling error an I don't know where or what it's referencing.
Error - Pin "I" is connected to a bus of a different width.
I don't have a Pin "I" that I can see anywhere in the ISE Schematic
Software - ISE 14.7, xc9572XL (See Attached)
Any advice would be appreciated.
11-29-2020 11:21 PM
Hi All,
I've figured out the issue, there were buffer symbols within the schematic which were the source of the 'I' Error.
There was a Array size mismatch on either side of the buffer.
Solved.
11-19-2020 07:49 PM
Thankyou for reviewing my issue, has anyone seen the same issue or are able to provide an feedback on the issue?
11-29-2020 11:21 PM
Hi All,
I've figured out the issue, there were buffer symbols within the schematic which were the source of the 'I' Error.
There was a Array size mismatch on either side of the buffer.
Solved.