cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
KiteSurfing
Newbie
Newbie
1,037 Views
Registered: ‎10-28-2020

ISE - Unknown Compile Error

Jump to solution

Hi All, 

I have an unknown compiling error an I don't know where or what it's referencing.

Error - Pin "I" is connected to a bus of a different width.

I don't have a Pin "I" that I can see anywhere in the ISE Schematic

Software -  ISE 14.7, xc9572XL (See Attached)

Any advice would be appreciated.

Tags (3)
0 Kudos
1 Solution

Accepted Solutions
KiteSurfing
Newbie
Newbie
804 Views
Registered: ‎10-28-2020

Hi All, 

I've figured out the issue, there were buffer symbols within the schematic which were the source of the 'I' Error.

There was a Array size mismatch on either side of the buffer.

Solved.

 

View solution in original post

0 Kudos
2 Replies
KiteSurfing
Newbie
Newbie
864 Views
Registered: ‎10-28-2020

Thankyou for reviewing my issue, has anyone seen the same issue or are able to provide an feedback on the issue?

0 Kudos
KiteSurfing
Newbie
Newbie
805 Views
Registered: ‎10-28-2020

Hi All, 

I've figured out the issue, there were buffer symbols within the schematic which were the source of the 'I' Error.

There was a Array size mismatch on either side of the buffer.

Solved.

 

View solution in original post

0 Kudos