Using xil_printf on admxrc2v3000

[nits11]

Hie,

I am trying to run c compiled code on microblaze containg Xil_printf statements.

I run that successfully on digilent board using uart as stdout ( intterface generated by edk).

But i am not able to run that on admxrc2 (alpha data board) as there is only a PCI interface available.

Even the board is not supported on edk.

Any suggestion would be great.

Thanks.

[htsvn]

Hi,

Do you have a JTAG inteface ? If yes you can use MDM to be used as a hyperterminal.

Please refer page 7 Processor STDIN/STDOUT of this Application Note.

http://www.xilinx.com/support/documentation/application_notes/xapp996.pdf

Thnx.

[anuragmurty]

Hey nits11,

Were you able to solve your problem? If yes, please guide me how you did it.

I am facing the same problem with implementing a microblaze on alpha data cards actually.

Thanks,.

Anurag