UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer jiang1
Observer
4,194 Views
Registered: ‎06-20-2013

partial reconfiguration selectMap to kintex7

block_picture.jpgHi,

     FPGA:  kintex 7 325t;

     ARM : am3352

     design tools: ISE14.7  and PlanAhead14.7

 

       I  study the datasheet ug702 for partial reconfiguration; and use tool PlanAhead to generate bits; I select the mothod of slave selectMap to config FPGA; so I use IMACT tool to generate byte-swap bins;

      when I use ARM to config the full bin ,  it is successful to config FPGA;  but when I use ARM to config the partial bin , it is fail to config FPGA;  I  use JTAG config FPGA with full bits and partial bit,  it is ok;

      when config full bin ,arm make program signal zero and one;  when config partial bin , arm directly config bin file to FPGA without using program signal ;

     so, my question is the reseon of config partial bin without sucess using slave selecMAp ;

 

     thanks,  the problem beset me for long time;

 

   

I hope you can help me.

 

Best regards,

 

     

        

 
0 Kudos