cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
557 Views
Registered: ‎02-13-2019

Use MIO to turn on LEDs on board Cora Z7

Hello everyone,

I am trying to control the output of the LEDs of my board with MIO, as shown in this example. The thing is that looking at the schematic of my Cora Z7 board, the LEDs do not appear in  the MIO bank.

Is it at all posssible that the board does not offer the possibility to configure MIO rgb leds as outputs?

Best regards.

 

MIO_bank.PNG
0 Kudos
2 Replies
Highlighted
522 Views
Registered: ‎06-21-2017

Can you configure a bank of your PS GPIO as EMIO and declare the pins to be the ones that the LEDs are connected to?

Highlighted
Visitor
Visitor
502 Views
Registered: ‎02-13-2019

Hello @bruce_karaffa, it looks like you are pointing at the right direction.

I found this page that provides a set of guidelines to use GPIO via EMIO.

0 Kudos