cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tflekan_ddc
Visitor
Visitor
364 Views
Registered: ‎03-01-2021

Problem generating HBM IP

Jump to solution

I have a design with a target of Virtex Ultrascale xcvu35p-fsvh2104-2-e (active).  When I generate the HBM IP I get a missing component called ONE_STACK.  I'm using the default options for generating the IP and there are no errors during synthesis.  I can't figure out why I don't see ONE_STACK.

Tags (1)
hbm_mem_controller.PNG
0 Kudos
1 Solution

Accepted Solutions
kshimizu
Xilinx Employee
Xilinx Employee
267 Views
Registered: ‎03-04-2018

Hello @tflekan_ddc ,

 

What is the issue?  I could pass the implementation.  Hbm.xci is IP, so you don’t care about it.

 

 

Best regards,

Kshimizu

 

Product Application Engineer Xilinx Technical Support

-------------------------------------------------------

Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.  Please Give Kudos.

-------------------------------------------------------

View solution in original post

3 Replies
kshimizu
Xilinx Employee
Xilinx Employee
268 Views
Registered: ‎03-04-2018

Hello @tflekan_ddc ,

 

What is the issue?  I could pass the implementation.  Hbm.xci is IP, so you don’t care about it.

 

 

Best regards,

Kshimizu

 

Product Application Engineer Xilinx Technical Support

-------------------------------------------------------

Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.  Please Give Kudos.

-------------------------------------------------------

View solution in original post

tflekan_ddc
Visitor
Visitor
248 Views
Registered: ‎03-01-2021

The issue is that I cannot simulate the HBP IP.  I've read the user guide and found out that Vivado will not simulate the HBP IP; this is a disappointment because I don't have access to ModelSim Questa or VCS.

0 Kudos
kshimizu
Xilinx Employee
Xilinx Employee
199 Views
Registered: ‎03-04-2018

Hello @tflekan_ddc ,

 

Thanks for your reply.  As you mention, Vivado sim is not supported at this point.  So, please use the 3rs-party Sim.

 

 

Best regards,

Kshimizu

 

Product Application Engineer Xilinx Technical Support

-------------------------------------------------------

Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.  Please Give Kudos.

-------------------------------------------------------

0 Kudos