cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
2,668 Views
Registered: ‎02-06-2012

Using MIG to implement QDRII (non+)

Jump to solution

The XAPP886 describes how to change a QDRII+ MIG core to a QDRII (non-plus). In theory this is a simple change of burst width and a state machine (which it doesn't specify the location of any further). The XAPP (http://www.xilinx.com/support/documentation/application_notes/xapp886_Interfacing_QDR_II_SRAM_Devices_with_V6_FPGAs.pdf)

Describes files attached with it however I cannot seem to find a link to these files. Do any of you know where I might find these files? Also is this document even relevant to version 3.92 of the MIG as it was written for version 3.4 (ISE 12)?

 

 

Thanks,

 

richard 

 

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
2,790 Views
Registered: ‎08-16-2007

Re: Using MIG to implement QDRII (non+)

Jump to solution

The reference design files for this application note can be downloaded at:

https://secure.xilinx.com/webreg/clickthrough.do?cid=154544

 

View solution in original post

1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
2,791 Views
Registered: ‎08-16-2007

Re: Using MIG to implement QDRII (non+)

Jump to solution

The reference design files for this application note can be downloaded at:

https://secure.xilinx.com/webreg/clickthrough.do?cid=154544

 

View solution in original post