cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
zhfsongsong
Adventurer
Adventurer
7,101 Views
Registered: ‎11-27-2014

ise_flow.bat failed in bitgen step

Jump to solution

    I cereat a mig ip core with debug function,after the core generated,i run the "ise_flow.bat"in "*/example_design/par" through  ISE suite design command prompt .But,i tried twice,all the steps is succeed except the last bitgen .

    Did i forgot something needed by bitgen or did i do something wrong?

    

0 Kudos
1 Solution

Accepted Solutions
criley
Xilinx Employee
Xilinx Employee
12,951 Views
Registered: ‎08-16-2007

What's the error message reported by bitgen?

View solution in original post

0 Kudos
2 Replies
criley
Xilinx Employee
Xilinx Employee
12,952 Views
Registered: ‎08-16-2007

What's the error message reported by bitgen?

View solution in original post

0 Kudos
zhfsongsong
Adventurer
Adventurer
7,077 Views
Registered: ‎11-27-2014

thank you, i just checked the "ise_flow_results.txt" found there is  pins which have locations (LOC) that are
not user-assigned or I/O Standards (IOSTANDARD) that are not user-assigned. i will check it again.

thanks.

0 Kudos