UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Observer rrx
Observer
257 Views
Registered: ‎04-03-2018

10/25g axi enet counts at 0

Jump to solution

Hello

 

We are using multiple 10G cores/blocks in our design. Ones from PG210 publications.  I can see counts being pegged for rx/tx packets/bytes and sizes.  However, the counts for unicast/mult/broadcast remain at 0. I dont see anything to enable/disable particular group. Any ideas ? We are passing traffic so I would see those counts to increment.

0 Kudos
1 Solution

Accepted Solutions
Observer rrx
Observer
192 Views
Registered: ‎04-03-2018

Re: 10/25g axi enet counts at 0

Jump to solution

yes.. we will give this a  try tomorrow/day after ...

0 Kudos
4 Replies
Observer rrx
Observer
256 Views
Registered: ‎04-03-2018

Re: 10/25g axi enet counts at 0

Jump to solution
BTW.. we are on 2018.3
0 Kudos
Highlighted
Xilinx Employee
Xilinx Employee
212 Views
Registered: ‎04-16-2008

Re: 10/25g axi enet counts at 0

Jump to solution
In 2018.3, the unicast/multcast and broadcast check logic is only getting enabled if pause logic is selected when the core is generated. Can you try generating the logic with pause enabled?
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
Observer rrx
Observer
193 Views
Registered: ‎04-03-2018

Re: 10/25g axi enet counts at 0

Jump to solution

yes.. we will give this a  try tomorrow/day after ...

0 Kudos
Observer rrx
Observer
151 Views
Registered: ‎04-03-2018

Re: 10/25g axi enet counts at 0

Jump to solution

thanks. That worked.

0 Kudos