UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor dager168
Visitor
2,278 Views
Registered: ‎02-14-2015

RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

Hi everyone

Now I am debugging the connection between the phy IC and the rxaui PCS/PMA.

the phy IC  apply 8/10 encoding first and then interleave at the 10bit level as default , but the pg083 just  descriped as follow " the data on each lane is 8B/10B encoded before transmission " Does it mean that the coding before interleave ?

 

after I changed the setting to " interleave two 8bit stream first and then apply 8/10 encoding',the connection between phy IC and  rxaui PCS/PMA success.

 

So my question is that whether the rxaui uses coding before interleave  or not!

 

0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
4,041 Views
Registered: ‎02-06-2013

Re: RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

Hi

 

The core interleaves the two channels and then 8b10b encoding is done in the transceivers

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------
4 Replies
Xilinx Employee
Xilinx Employee
4,042 Views
Registered: ‎02-06-2013

Re: RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

Hi

 

The core interleaves the two channels and then 8b10b encoding is done in the transceivers

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------
2,253 Views
Registered: ‎01-08-2012

Re: RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

I believe the interleaving is meant to happen at the 10B level.

 

I would refer you to the specification, but I can't find an online link on Marvell's website right now.  There seems to be a copy cached at Opencores though.

 

Allan

0 Kudos
2,252 Views
Registered: ‎01-08-2012

Re: RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

@yenigal wrote:

Hi

 

The core interleaves the two channels and then 8b10b encoding is done in the transceivers


I'm curious - when the Xilinx core was tested, what was it tested against?

0 Kudos
Visitor dager168
Visitor
2,219 Views
Registered: ‎02-14-2015

Re: RXAUI 8b/10b coding before interleave or interleave before coding

Jump to solution

Thanks a lot!

could you tell me which document describe the details?

0 Kudos