cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
10,713 Views
Registered: ‎02-26-2016

Artix 7 Power Isolation

I have not been able to find information as to which power supplies appart from VCCAUX, need to be isolated on the Artix 7.

 

Is it necessary to isolate VVCINT and VVCBRAM with a ferrite bead or inductor? What is best practice?

 

Is it also neccessary to isolate VCCO_## power supplies with a ferrite bead or inductor? Again what is best practice?

 

Are LDO's preffered over DC/DC converters for the MGTAVCC and the MGTAVTT power supplies? Will the LDO provide sufficent isolation from the noise generated from the FPGA's digital switching?

Tags (2)
0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
10,564 Views
Registered: ‎08-01-2012

If VCCINT and VCCBRAM are operating at the same voltage, VCCINT and VCCBRAM should be connected to the same supply. This was mentioned in Foot note 3 of Table-2 in http://www.xilinx.com/support/documentation/data_sheets/ds181_Artix_7_Data_Sheet.pdf

 

I do not think ferrite bead/ inductor is mandatory requirement in this case (where VCCINT and VCCBRAM are operating at the same voltage). Without ferrite bead / inductor also it works. We recommend to mount all decoupling capacitors as per PCB design user guide recommendations.

 

 

________________________________________________

Please mark this post as an "Accept as solution" in case if it helped to resolve your query. So that it will help to other forum users to directly refer to the answer.

Give kudos to this post in case if you think the information is useful and reply oriented.

0 Kudos