cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
sweet12prof
Observer
Observer
711 Views
Registered: ‎04-05-2019

DCM and MMCM

Jump to solution

Are the Locked Outputs for both similar ?

I read from another thread, here , where it was suggested to alternatively use the LOCKED output of an MMCM in the implementation of a reset.

I'm curious as to whether this will work in DCMs too

0 Kudos
Reply
1 Solution

Accepted Solutions
hermanfisher1994
Contributor
Contributor
646 Views
Registered: ‎12-10-2018
Yes, they are the same. You can use the locked output of DCM as reset, too. It has a same behavior and it says the clock is ready and stable. So it can be used as an active-low reset.
-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution.
-------------------------------------------------------------------------------------------------------------------------------

View solution in original post

3 Replies
hermanfisher1994
Contributor
Contributor
647 Views
Registered: ‎12-10-2018
Yes, they are the same. You can use the locked output of DCM as reset, too. It has a same behavior and it says the clock is ready and stable. So it can be used as an active-low reset.
-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution.
-------------------------------------------------------------------------------------------------------------------------------

View solution in original post

drjohnsmith
Teacher
Teacher
609 Views
Registered: ‎07-09-2009
yes
<== If this was helpful, please feel free to give Kudos, and close if it answers your question ==>
sweet12prof
Observer
Observer
564 Views
Registered: ‎04-05-2019
sorry for getting back late. But i tried and it worked! Thanks a lot.