06-28-2016 12:31 PM
I generated bitfile for my board, Basys 3 and ran the program. But it would not go beyond 1% . So, I had to force stop the program and start again but I am not able to reset my fpga board. When I press the FPGA configuration reset button, an orange led light,LD16 turns on indicating busy. Even the display is not working. I am not able to run any programs. How do I solve this?
08-17-2016 08:59 PM
@bluecom It will be more helpful if you can mention what steps you did and which guide you followed and where you are stuck.
Were you able to perform all the steps in above link?
08-22-2016 08:21 PM
Dear ,I want to display as "1","2","3","4" on seven-segments, but I can not ,could you give me a DEMO source code?
and let me know how to do in step by step,and to the end perfectly.
08-31-2016 08:45 PM
there have some errors,how can I do next
launch_xsim -simset sim_1 -mode behavioral
[Runs 36-25] xelab application returned error(s). Please see 'F:/baojf/project_20160901/project_20160901.sim/sim_1/behav/xelab.log' file for more details.
[Common 17-69] Command failed: Failed to compile the design!