cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ceemon_1
Visitor
Visitor
500 Views
Registered: ‎07-18-2018

Spartan7 - Unable to view static operational current for maximum process variation with XPE

I'm doing a power estimation with XPE for a Spartan-7 XC7S25 device which I plan to use on a low power PCB I am designing.  When I change the Process settings from Typical to Maximum the current draw for VCCINT increases considerably.  This is due to the startup current and the value is shown in blue.

 

While this is good information, I need a way to view the operational current (after configuration) for the maximum process.  Is there a way for me to view the operational current when it is less than the startup current for the maximum process?

 

 

0 Kudos
Reply
0 Replies