cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
977 Views
Registered: ‎12-15-2017

Use of 'No Load' resistors in Arty board schematic

Jump to solution

 

I'm referring the Arty Board schematic. What is the necessity of using some resistors marked as "No Load"  in some pins? Some of them have values 0,100 etc.

 

Thank you...

Tags (3)
0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
1,081 Views
Registered: ‎04-18-2011
Often the board designer may add resistors in as an option and then decide later to populate it on the board.
So for instance you may need to pull up or pull down a pin depending on the mode so both options are added but only one ends up populated
I suspect this is the case here
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

1 Reply
Highlighted
Moderator
Moderator
1,082 Views
Registered: ‎04-18-2011
Often the board designer may add resistors in as an option and then decide later to populate it on the board.
So for instance you may need to pull up or pull down a pin depending on the mode so both options are added but only one ends up populated
I suspect this is the case here
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post