cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
rbryan3
Visitor
Visitor
320 Views
Registered: ‎02-05-2021

Editing MCAP Register Base in MCAP driver for Windows 10

Hi,

I read that there is an issue using the xilinx mcap driver with Ultrascale+ devices in that the start of the MCAP VSEC points to the wrong address.  I am attempting to change the base value from 0x340 to 0x350 but I cannot find any instructions with regards to building the driver.  When I do try to build I get a warning saying "MSB8005: The property 'NMakeBuildCommandLine' doesn't exist."  Is there an updated mcap driver for windows 10?  I am working with a VCU118 in Vivado 2020.2.  Or has anyone ran into this and been able to figure out how to build the driver? 

 

Thank you,

Kyle

Tags (3)
0 Kudos
2 Replies
pvenugo
Moderator
Moderator
260 Views
Registered: ‎07-31-2012

@rbryan3 ,

Please refer to https://xilinx.github.io/dma_ip_drivers/master/XVSEC/xvsec_linux/index.html for MCAP latest driver.

 

Regards

Praveen


-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
rbryan3
Visitor
Visitor
191 Views
Registered: ‎02-05-2021

@pvenugo ,

Thank you for responding, I was looking for info on windows 10 drivers though.  Our team ended up switching to a linux redhat machine and was able to utilize the linux mcap drivers.