cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
388 Views
Registered: ‎08-15-2017

in the figure ,which part is configured by the bit file?

Jump to solution

there are LogiCORE IP, PCIE_2_1, Transceivers in the figure,my question is:336.png

1) Transceivers is fixed in the FPGA?

2) PCIE_2_1 is configured by the bit file ?

 

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
329 Views
Registered: ‎01-15-2008

yes, for 7 series there is no option to change the GT locations in the IP wizard so you will need to use the GT locations used by the PCIE IP. Also it is advised to keep as it is to meet the timing.

PCIE_2_1 IP setting is done in the IP wizard and after implementation the bit file will have the details to configure it according to your requirement.

View solution in original post

0 Kudos
1 Reply
Highlighted
Moderator
Moderator
330 Views
Registered: ‎01-15-2008

yes, for 7 series there is no option to change the GT locations in the IP wizard so you will need to use the GT locations used by the PCIE IP. Also it is advised to keep as it is to meet the timing.

PCIE_2_1 IP setting is done in the IP wizard and after implementation the bit file will have the details to configure it according to your requirement.

View solution in original post

0 Kudos