cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Visitor
Visitor
390 Views
Registered: ‎01-14-2019

Configuring I2C controller on Zynq+ to run SMB protocol

We are working on a soultion that is based on a Zynq® UltraScale+™ MPSoC  XCZU6EG part

We need to support SMB protocol to interface  one of the battrey chargers.

Since there are two I2C in the PS, we paln to use the second I2C (to run SMB) and route to the EMIO.

Do we need to look for a specific (IP)  and driver to support SMB bus protocol?

We need make sure that driver will work in bare metal and/or linux OS

Alex

Tags (2)
0 Kudos
Reply
0 Replies