cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
cascade99
Observer
Observer
6,020 Views
Registered: ‎12-05-2015

Erase flash failed

Jump to solution

Hi,

I was using SDK2016.2 to "Programing Flash" but got error:

CortexA9 Processor Configuration
-------------------------------------
Version.............................0x00000003
User ID.............................0x00000000
No of PC Breakpoints................6
No of Addr/Data Watchpoints.........4
Processor Reset .... DONE
SF: Detected S25FL128S_64K with page size 256 Bytes, erase size 64 KiB, total 16 MiB
Performing Erase Operation...
ERROR: attempting erase past flash size (0x1000000)
Erase Operation failed.
INFO: [Xicom 50-44] Elapsed time = 0 sec.

ERROR: Flash Operation Failed

Anybody know why? I checked the cable, looks fine.

Thanks

 

0 Kudos
1 Solution

Accepted Solutions
vijayak
Xilinx Employee
Xilinx Employee
10,241 Views
Registered: ‎10-24-2013

Hi @cascade99

Please check where the similar topic is discussed.

https://forums.xilinx.com/t5/Embedded-Linux/Unable-to-boot-petalinux-from-flash/td-p/555692

Thanks,Vijay
--------------------------------------------------------------------------------------------
Please mark the post as an answer "Accept as solution" in case it helped resolve your query.
Give kudos in case a post in case it guided to the solution.

View solution in original post

0 Kudos
2 Replies
vijayak
Xilinx Employee
Xilinx Employee
10,242 Views
Registered: ‎10-24-2013

Hi @cascade99

Please check where the similar topic is discussed.

https://forums.xilinx.com/t5/Embedded-Linux/Unable-to-boot-petalinux-from-flash/td-p/555692

Thanks,Vijay
--------------------------------------------------------------------------------------------
Please mark the post as an answer "Accept as solution" in case it helped resolve your query.
Give kudos in case a post in case it guided to the solution.

View solution in original post

0 Kudos
cascade99
Observer
Observer
5,920 Views
Registered: ‎12-05-2015

It turned out that the my .bin file is too big for single QSPI, i need set to dual parallel when I do Program Flash.

 

Thanks