I am new and I need helps with this I2C issue. I want to connect a Aardvark I2C/SPI Host adapter to the J4 PMBUS connector of the Xilinx ZC706 board. I found these signals on Xilinx J4 connector: PMBUS CTRL,PMBUS CLK, PMBUS ALERT, and PMBUS DATA, GND.
For the hardware connection, Is it correct that I only need to connect SDA to PMBUS Data, SCL to PMBUS CLK, GND to GND and voltage?
What are the requirements, configure, software application that I need to download and setup so that I can run and scope these I2C signals?