cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Explorer
Explorer
1,780 Views
Registered: ‎07-29-2009

Inferring SPI interface

I'm trying to interface with the SPI bus from the zynq EMIO in the fabric. I'm trying to create IP and have it use the SPI interface:

spi_bus_interface_zynq.PNG

As you can see, this doesn't even slightly match the ports provided with the interface:

spi_bus_interface.PNG

Is there a definition of what should go where and what corresponds to what?  Some are obvious, but it isn't clear.

Tags (1)
0 Kudos
Reply
1 Reply
Highlighted
Moderator
Moderator
1,731 Views
Registered: ‎07-31-2012

Hi,

 

See if this reply https://forums.xilinx.com/t5/Zynq-All-Programmable-SoC/Zynq-connect-PS-SPI-peripheral-through-EMIO-with-external-device/m-p/600394#M7321 in the linke helps you.

 

Regards

Praveen


-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Reply