09-10-2019 10:41 PM
Please someone respond for this, i am in lack of time. I have been checking in user guides but didn't get any information. Make your suggestions, your help is highly appreciated.
09-11-2019 06:58 AM
I haven't reset the PS from the PL but the interrupts I generate that need to be sent to the PS from the PL I do by enabling these settings in the PS configuration.
Note that you need to use a Concat block to input an interrupt into the pl_ps_irq as it is defined as a vector.
Otherwise you may need to output from a PL pin to the PS POR pin at board level to do this.
09-11-2019 07:13 AM
Thanks for the responce.
I am doing this in the design for some other functionality, in PL i have output port that i have driven directly to the pl_ps_irq port to MPSOC. What is contact block here ?
Otherwise you may need to output from a PL pin to the PS POR pin at board level to do this. Is this statement for resetting MPSOC ?
but i want to reset PS. Is there any other way to reset PS like writing into any soft reset register etc ..?
09-11-2019 07:15 AM
09-12-2019 06:14 AM
Thanks for the link, it helped to find some registers.
I find some registers (RESET_CTRL (CRL_APB) and GLOBAL_RESET (PMU_GLOBAL) ), can we access these register from PL ? if not how to access these registers.
Any idea on that Linux command or watchdog timeout ?
09-12-2019 02:42 PM
09-12-2019 02:44 PM
09-12-2019 11:50 PM
Thanks for the reply Watari.
I haven't tried that commands, i will try. Where can i type this commands (on SDK terminal) hence i have loaded FSBL and Bin from SDK.