cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
golson
Scholar
Scholar
6,211 Views
Registered: ‎04-07-2008

Testing XAPP957 questions

Hi,
  I implemented the XAPP957 design on my ML505 board.  I have a lot of questions about how to test and configure the Test Application.
 
Among them is some times the DEMO test does not always capture packets in the rx fifo.  I have seen it catch maybe 10 sometimes when
I push the demo button.  And then Another time it may catch one and sometimes 0. 
 
Another question I have is that I try to send packets using the auto and watch packet traffic.  But the receiver counts these packets as packet
fragments and not captured packets.  I think I need to tell it the IP address of the receiver for it to recognize the packets as valid packets.
 
If this is so, How do I configure this.
 
Thank You,
  Gary Olson
 
0 Kudos
0 Replies