01-04-2019 02:27 AM
Using my zturn board, I am trying to read and output the sensor data through serial terminal. I am able to receive output on the putty terminal once I program my FPGA and run/debug my software code. When I tried to boot from SD card, i am getting the signal at the ports. However, I am not getting an output on the terminal. The same happens when I try to boot through flash. The software side is not working. Please help.
01-16-2019 11:04 PM
01-17-2019 12:01 AM
Hi, thanks for the reply. Whenever I add a new ZYNQ_FSBL application into the project, i am getting the following warnings.
Even though those were the warnings, I still used this fsbl to create the image. The board was not even booting in this case.
So I used the zynq fsbl fiile from my old Hello World program to boot the board. I was able to get the output signals from the board. However, UART was not working in this case.