05-03-2015 09:06 AM
Hello, I am trying to communicate with an I2C slave that requires 1.5 kOhm pullup resistors on SCL/SDA. I was going to solder in physical resistors myself, but then remembered the pullup column in the Vivado configurator (attached).
I can change the "disabled" to enabled easily enough, but I cannot find any documentation on what pullup resistor values is used in Zynq. On the MIO pins, the pullup can be en/disabled through MIO register, so I wondered what this pullup option does exactly. Can you please refer me to a documentation that lists the pullup resistor values used inside the Zynq chip?