03-30-2018 07:58 PM - edited 03-30-2018 11:10 PM
In Vivado 2016.2,
my board design is as the picture below,
,Microblaze is connected to BRAM through DLMB/ILMB pins,so it will run the instructions located in BRAM, but i would like to Microblaze to run codes on DDR,How can i do?thanks
04-01-2018 02:30 PM
04-02-2018 11:48 PM
thanks for your kindly reply.
In your designs here there is no LMB connected to Microblaze ,and my designs have,my problem is that if there is a LMB connected to Microblaze ,could Microblaze execute application located in DDR?how i must to do ?thanks