cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
425 Views
Registered: ‎08-12-2018

use iomodule together with other ips in microblaze system

I am using the microblaze processor. Now I need ips such as iobus, iic, uart. But I can't find an iobus ip alone. The ip IOModule does include the iobus function, but when I build a block design with microblaze, iomodule and other ips, the sysyem failed. What's wrong of my design? And is there any other ways that I can use iobus with other ips in microblaze design?
Thanks!
0 Kudos
1 Reply
Highlighted
Moderator
Moderator
376 Views
Registered: ‎07-31-2012

Hi @singularwoo,

 

You need to enable IO bus in IO module configuration under System tab.

Refer to figure 4-2 in https://www.xilinx.com/support/documentation/ip_documentation/iomodule/v3_0/pg111-iomodule.pdf

 

Regards

Praveen


-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos