UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Adventurer
Adventurer
213 Views
Registered: ‎04-29-2018

I2C issue on custom zynq board

I have a custom zynq board, with I2C controlled from PS and having 5 slave devices connected through I2CMUX.

Out of 5 slaves, one of the slave device is I2C Aardvark programmer. I am trying to program the registers of one of my slave device using Aardvark, but having issue's in talking to the device.

Is it possible to configure ZynqPS as slave and Aardvark as Master, if so can you please suggest some steps to do it. Or let me know if there are other solutions to it.

 

0 Kudos
1 Reply
Moderator
Moderator
177 Views
Registered: ‎06-27-2017

Re: I2C issue on custom zynq board

Hi @trinadhkosuru ,

This can be possible as Zynq PS I2C is capable of configured to slave also.

Please refer the document mentioned in below forum post. It is verified that Advark master is able to communicate with PS i2c slave.

https://forums.xilinx.com/t5/Embedded-Linux/how-to-use-i2c-cadence-driver-in-slave-mode/td-p/850068

Best Regards
Kranthi
--------------------------
Don't forget to reply, kudo, and accept as solution.
0 Kudos