UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Adventurer
Adventurer
1,430 Views
Registered: ‎03-20-2016

Whether it is possible to program a FPGA(zynq fpga) using ARM PL JTAG,if possible then which cable i have to use and how to program?

Hello everyone,

             I am using Zynq ZC702 evaluation board.whether it is possible to program a bit file using ARM PL JTAG,If it is possible then please let me know how to do that.And which cable i have to use for programming the FPGA?

 

 

Thanks

0 Kudos
1 Reply
Moderator
Moderator
1,423 Views
Registered: ‎11-09-2015

Re: Whether it is possible to program a FPGA(zynq fpga) using ARM PL JTAG,if possible then which cable i have to use and how to program?

Hi @deepak1991,

 

Yes this is possible to program the PL using the JTAG:

-> use the platform cable if you have one

-> use a USB to micro USB cable to connect with the USB JTAG interface using a Digilent module

 

Remember to select the JTAG configuration for the SW16.

 

Hope that helps,

 

Regards,

 

Florent


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos