03-08-2017 06:32 PM
After SDx 2016.3 was installed, there is NO hardware platform available to use.
How to install these hardware platforms as shown in the attached pic?
03-08-2017 08:57 PM
03-09-2017 08:36 AM
03-09-2017 09:04 AM
03-09-2017 11:18 AM
Thanks for your reply. Yes, it should be the license issue.
The network name eth0 is correct. My problem is that I used wifi to have internet access. After I connect the computer with a cable via eth0 port, I have some platforms available to use.
But it appears only zynq platforms are available. NO PCIe SDAccel platforms available.
Now I tested the SDAccel on a laptop, without PCIe or eval card installed.
Could it be the problem?
03-09-2017 12:18 PM
Verify that you have the correct license downloaded in the correct location.
The default location is
To check run (in bash)
export -p | grep XILINXD
You should see
declare -x XILINXD_LICENSE_FILE="/home/<some_username>/.Xilinx/Xilinx.lic"
You do not need a PCIe card installed to target a PCIe platform.
03-09-2017 02:23 PM
@sl_cgi The SDSoC license will give you access the embedded platforms that you are seeing. This will not work for the PCIe platforms you asked about.
For the time being, the best way for you to get access to the SDAccel platforms is through the Nimbix Cloud.