09-17-2019 08:10 AM
I am running a simulation in ModelSim from Vivado.
When I run it, it auto-generates and runs a file: "testbench_wave.do"
I would like to turn this off and use "testbench.udo" to add my own waveform.
Can someone please tell me how to do this as I cannot find any settings in the GUI that allow me to stop this from happening.
Can you also point me in the direction of documentation that describes these settings so that I can explore further issues I am having without needing to create more tickets.
09-17-2019 05:42 PM
You may try to specify modelsim.simulate.custom_wave_do setting.
You can refer to UG900 for descriptions on these options.
10-10-2019 12:25 AM
Then you may want to try creating a custom .do file that contains all simulation commands, including adding waveform signals, and specify custom_do option to point to this file.
10-21-2019 04:20 AM
Hi @luke_richardson ,
You could try the launch_simulation -scripts_only command to generate the scripts for the compile, elaborate and simulate do files.
This way you can maually run the scripts that you wish.