cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
jl.fragoso
Visitor
Visitor
456 Views
Registered: ‎06-09-2016

Disable timing check

I'm trying to run a SDF annotated simulation without the timing checks in batch mode.

When I run it with timing checks it works and print timing checks messages (as expected). 

However, adding the option "-notimingchecks" on xelab command it prints a bunch of 

"WARNING: [XSIM 43-3486] Unable to locate information about setup construct between ports R and C for SDG instance counter_reg[9] of module FDRE_default."

on different register and fails without any message (no error or anything).

Any ideas/suggestions??

0 Kudos
1 Reply
harikade
Xilinx Employee
Xilinx Employee
398 Views
Registered: ‎05-01-2019

Hi,

Please use "-v 2" with xelab command to get more information.

If possible, please provide us your design to analyze it at our end.

Thanks,

Harika.

0 Kudos