cancel
Showing results for 
Search instead for 
Did you mean: 
Adventurer
Adventurer
8,575 Views
Registered: ‎09-07-2015

Open waveform config file in vivado

Jump to solution

Hi,

 

I searched the answer of course in the forum. 

In this solution doesn't my answer

http://www.xilinx.com/support/answers/64116.html

 

I want to open directly last waveform without say run simulation in vivado. Because this take again extra time and start only simulation doen't show last window.

 

I want to see my last window speedly?? Also,

I wanto save waveform to jpeg,pdf.. Is it possible this inside from vivado??

 

thanks

 

 

 

1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
15,897 Views
Registered: ‎04-17-2011

Re: Open waveform config file in vivado

Jump to solution
For that you need the .wdb and .wcfg file and you can follow the steps below:
1. Open Vivado GUI.
2. In the TCL console, type: cd {to the path where .wdb & .wcg is present}
3. Type: current_fileset
4. open_wave_database xxxx.wdb
5. open_wave_config xxxx.wcfg

And, it is not possible to save the waveform in jpeg or pdf. You can create a VCD file if that helps you from Vivado.
Regards,
Debraj
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

2 Replies
Highlighted
Moderator
Moderator
15,898 Views
Registered: ‎04-17-2011

Re: Open waveform config file in vivado

Jump to solution
For that you need the .wdb and .wcfg file and you can follow the steps below:
1. Open Vivado GUI.
2. In the TCL console, type: cd {to the path where .wdb & .wcg is present}
3. Type: current_fileset
4. open_wave_database xxxx.wdb
5. open_wave_config xxxx.wcfg

And, it is not possible to save the waveform in jpeg or pdf. You can create a VCD file if that helps you from Vivado.
Regards,
Debraj
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

Highlighted
Adventurer
Adventurer
8,525 Views
Registered: ‎09-07-2015

Re: Open waveform config file in vivado

Jump to solution

Thank you, I didn't stay tuned.

0 Kudos