cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
9,459 Views
Registered: ‎06-03-2013

Trouble finding Unit Under Test file during simulation

I am a new to the Xilinx ISE and iSim programs. I am working through the tutorial found attached. In the behavioral simulation chapter, on page 87 to be exact, the instructions say to expand the UUT file to be able to view the timing simulations of all of the inputs and outputs. Unfortunately, the UUT file does not apear under the test bench file as seen on the  picture on the same page. In the ISE where I created the project, the UUT file does exist, and is below the test bench file in the project design hierarchy. Does anyone know why this is happening? Thank you.

0 Kudos
3 Replies
Highlighted
Adventurer
Adventurer
8,727 Views
Registered: ‎08-15-2014

Re: Trouble finding Unit Under Test file during simulation

Please post the testbench you are using. Likely you just have the UUT named something else.

0 Kudos
Adventurer
Adventurer
8,726 Views
Registered: ‎08-15-2014

Re: Trouble finding Unit Under Test file during simulation

Also screenshots of your ISIM would be helpful to see if anything unusual is going on.

0 Kudos
Highlighted
Xilinx Employee
Xilinx Employee
8,709 Views
Registered: ‎10-24-2013

Re: Trouble finding Unit Under Test file during simulation

Hi,
Moving to simulation board.
Thanks,Vijay
--------------------------------------------------------------------------------------------
Please mark the post as an answer "Accept as solution" in case it helped resolve your query.
Give kudos in case a post in case it guided to the solution.
0 Kudos