cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor
Contributor
9,077 Views
Registered: ‎05-30-2014

cannot open macro file: system.do

Hi

I am a beginer for modelsim. I made a project as microblaze. then I wanted to simulate it.

I run modelsim through this command: make -f system.make sim

Then I run 4steps for simulation. the first step is : do system_setup.do;c

but this step cannot completely run and give an error : # cannot open macro file: system.do

"system" term is name of my project.

 

please help me

thanks

0 Kudos
2 Replies
Xilinx Employee
Xilinx Employee
9,061 Views
Registered: ‎02-06-2013

Hi

 

Check the below link

http://forums.xilinx.com/t5/Embedded-Development-Tools/I-can-t-simulate-my-EDK-design/td-p/31735

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------
0 Kudos
Highlighted
Contributor
Contributor
9,055 Views
Registered: ‎05-30-2014

This link is about the same problem. but there is not any suggestion about my problem!!!

please help me!
0 Kudos