cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Contributor
Contributor
721 Views
Registered: ‎01-30-2018

Switch nets invisible in schematic view

Jump to solution

Hello,

 

it is possible to Switch off nets in the schematic view of Vivado? In my large design, I can see only a green area and finding of the modules is extreme difficult.

 

Thank you for your help.

BR

 

Martin sauer

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
954 Views
Registered: ‎07-22-2008

There is not a switch to turn off nets per se but you could do the following.

1) with the schematic open run "select_objects [get_nets]" in the Tcl console

2) Right click in the Schematic window and select "Remove selected items from Schematic"

 

This will remove the nets from the display and you can add them back as desired by double clicking on pins, expanding the cone etc ...

View solution in original post

0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
955 Views
Registered: ‎07-22-2008

There is not a switch to turn off nets per se but you could do the following.

1) with the schematic open run "select_objects [get_nets]" in the Tcl console

2) Right click in the Schematic window and select "Remove selected items from Schematic"

 

This will remove the nets from the display and you can add them back as desired by double clicking on pins, expanding the cone etc ...

View solution in original post

0 Kudos