UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Explorer
Explorer
586 Views
Registered: ‎01-18-2011

EN_VTC during modifying QTR delay

Jump to solution

Hello

 

Whether BITSLICE_CONTROL.EN_VTC signal must be pulled Low during modifying PQTR/NQTR values?


 

0 Kudos
1 Solution

Accepted Solutions
Community Manager
Community Manager
619 Views
Registered: ‎08-08-2007

Re: EN_VTC during modifying QTR delay

Jump to solution

Doubled checked and you do not need to make the EN_VTC of the BSC low when changing the  PQTR/NQTR. It would be a good step after updating the PQTR/NQTR delay to read it back to make sure they got updated as programmed. 

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
2 Replies
Community Manager
Community Manager
503 Views
Registered: ‎08-08-2007

Re: EN_VTC during modifying QTR delay

Jump to solution

When you are changing the delays of the BITSLICE you are meant to pull the EN_VTC of the BITSLICE Low, so it makes sense to pull the EN_VTC of the BSC low when you make a PQTR/NQTR change so that two things are not trying to update at the same time. 

I'll try to verify that can get back to you.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
Community Manager
Community Manager
620 Views
Registered: ‎08-08-2007

Re: EN_VTC during modifying QTR delay

Jump to solution

Doubled checked and you do not need to make the EN_VTC of the BSC low when changing the  PQTR/NQTR. It would be a good step after updating the PQTR/NQTR delay to read it back to make sure they got updated as programmed. 

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------