UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Participant mnanoop2014
Participant
574 Views
Registered: ‎10-29-2018

Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution

Hi,

I have been following the Xilinx embedded design tutorial (UG1209).
When I press the add IP (+) button, and type in Zynq, the only IP visible in the drop down is Zynq ultrascale + VCU.

I am unable to figure out from where Zync Ultrascale + MPSoC IP can be added.

 

Edit: More info: Vivado 2018.2, Zynq Ultrascale+ MPSoC ZCU102-Evaluation board, node-locked licence that came with the board purchase.

 

TIA

Anoop

Untitled.jpg
0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator
523 Views
Registered: ‎02-09-2017

Re: Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution

Hi @mnanoop2014,

 

Can you double check in your project settings if the board ZCU102 is correctly selected (as in the image below)?

 

ZCU102_Settings.JPG

 

I suspect it might be set to a VCU instead.

 

Thanks,

 

Andre Guerrero

Product Applications Engineer

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
4 Replies
Moderator
Moderator
548 Views
Registered: ‎09-18-2014

Re: Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution

Mnanoop2014,

 

Which Zynq ultrascale+ device have you selected in Vivado? What version of Vivado? What vivado license package?

 

Regards,

T

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
Highlighted
Participant mnanoop2014
Participant
536 Views
Registered: ‎10-29-2018

Re: Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution
Info updated :)
0 Kudos
Moderator
Moderator
524 Views
Registered: ‎02-09-2017

Re: Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution

Hi @mnanoop2014,

 

Can you double check in your project settings if the board ZCU102 is correctly selected (as in the image below)?

 

ZCU102_Settings.JPG

 

I suspect it might be set to a VCU instead.

 

Thanks,

 

Andre Guerrero

Product Applications Engineer

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
Participant mnanoop2014
Participant
514 Views
Registered: ‎10-29-2018

Re: Unable to add zynq ultrascale IP in Vivado IP Integrator

Jump to solution
Silly me! I had not explicitly "clicked" on the board that appeared when I selected "Zynq Ultrascale+ ZCU102" from the drop down in "select board" screen, since that was the only board that popped up and there was neither a selection check box nor multiple entries.