UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Adventurer
Adventurer
909 Views
Registered: ‎02-12-2018

VirtexUltrascale+ : Difference between 2L and 2LV speed-grades

Jump to solution

Hi,

In Vivado under Virtex UltraScale+ device selection, for part xcvu9p-flga2104, I see below speed_grades:

      -2L-e and -2LV-e

I understan "L" denotes low power, but what about "LV".  I couldn't find much information about the differences between these two in the documentation or on the web. Which of these 2 is faster, and by how much?

 

Thanks

 

0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator
1,065 Views
Registered: ‎08-08-2017

Re: VirtexUltrascale+ : Difference between 2L and 2LV speed-grades

Jump to solution

Hi @xilinxmax

 

Yes . your understanding is correct.

----------------------------------------------------------------------------------------------------------------------------------------------

Reply if you have any queries , Give Kudos and accept as solution

-------------------------------------------------------------------------------------------------------------------------------------------

-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution
-------------------------------------------------------------------------------------------------------------------------------

View solution in original post

3 Replies
Moderator
Moderator
903 Views
Registered: ‎08-08-2017

Re: VirtexUltrascale+ : Difference between 2L and 2LV speed-grades

Jump to solution

Hi @xilinxmax

 

Basically these are the same parts with difference in VCCINT voltage.Capture.PNG

The lowest power -2L devices where VCCINT= 0.72V are included in VIVADO as -2LV.

 

Refer to the below forum discussion for more detailing .

https://forums.xilinx.com/t5/UltraScale-Architecture/What-s-the-difference-between-1L-and-1LV/td-p/777190

----------------------------------------------------------------------------------------------------------------------------------------------

Reply if you have any queries , Give Kudos and accept as solution

-------------------------------------------------------------------------------------------------------------------------------------------

-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution
-------------------------------------------------------------------------------------------------------------------------------
0 Kudos
Adventurer
Adventurer
893 Views
Registered: ‎02-12-2018

Re: VirtexUltrascale+ : Difference between 2L and 2LV speed-grades

Jump to solution

Hi,

 

Could you clarify if my understanding is correct.

     2LV - Low power (lesser than -2, -2L), reduced performance

     2L -  Low power (compared to -2, but more than -2LV), better performance compared to 2LV

Is that correct?

 

Thanks

 

 

0 Kudos
Moderator
Moderator
1,066 Views
Registered: ‎08-08-2017

Re: VirtexUltrascale+ : Difference between 2L and 2LV speed-grades

Jump to solution

Hi @xilinxmax

 

Yes . your understanding is correct.

----------------------------------------------------------------------------------------------------------------------------------------------

Reply if you have any queries , Give Kudos and accept as solution

-------------------------------------------------------------------------------------------------------------------------------------------

-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution
-------------------------------------------------------------------------------------------------------------------------------

View solution in original post