cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor
Contributor
465 Views
Registered: ‎10-04-2018

HDMI TX Subsystem Example Design

Jump to solution

Refer to PG235 chapter5, I followed the steps but I have chosen the design topology as TX only;  and I have generated a colorbar pattern with Zynq Ultrascale+ MPSoC ZCU104. But I want to generate this pattern as 4Kp30. Which things should I change on this design? And how would I know what is the resolution and frame rate of the pattern that I have generated?

Tags (2)
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
393 Views
Registered: ‎10-04-2017

Hi @yildizbilgin,

 

These are available in the uart menu.

This menu is available automatically after starting the project and following the hardware setup directions. (setting up the UART)

Don't forget to reply, kudo, and accept as solution.

Xilinx Video Design Hub

View solution in original post

1 Reply
Highlighted
Moderator
Moderator
394 Views
Registered: ‎10-04-2017

Hi @yildizbilgin,

 

These are available in the uart menu.

This menu is available automatically after starting the project and following the hardware setup directions. (setting up the UART)

Don't forget to reply, kudo, and accept as solution.

Xilinx Video Design Hub

View solution in original post