08-31-2020 02:35 AM
i am planning to create a custom board based on Zynq UltraSclae+ MPSoc device.
This device has DisplayPort controller but i dont want to use DisplayPort i want to use VGA cable. As the monitor i am going to use has only VGA port available.
Is there any way i can design the hardware to support VGA port instead of Display port.
I dont want to use any converter please advice if it's possible.
08-31-2020 06:32 AM
08-31-2020 08:42 AM
The other solution would be to not use thd Displayport controller and create your own logic to create a VGA controller in the PL
09-07-2020 04:37 AM - edited 09-07-2020 04:39 AM
09-07-2020 05:13 AM
If you use a DMA you wil be able to move data from PS to PL
09-07-2020 05:33 AM
09-07-2020 06:11 AM