cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Participant
Participant
349 Views
Registered: ‎07-04-2018

MIPI RX Design Simulation Doesn't Work

Jump to solution

 I want to use mipi d-phy rx in my pl project.

But I'm not familiar with this IP, so in my own simulation project , this ip dosen't work . When the "core_rst" is complete,the "init_done" is not from "0" to "1".

Where can I get some simulation examples about  mipi d-phy rx ?

Thanks!

 

Tags (2)
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
280 Views
Registered: ‎11-09-2015

HI @shixiaoke 

As mentioned by @dpaul24 , all the steps to generate the example design for the MIPI D-PHY IP are mentioned in the PG202


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

2 Replies
Highlighted
Scholar
Scholar
334 Views
Registered: ‎08-07-2014

@shixiaoke,

RT*D.....the xilinx docu has an example_design which should explain how simulating the core works.

MIPI D-PHY v4.1 LogiCORE IP Product Guide - Xilinx

--------------------------------------------------------------------------------------------------------
FPGA enthusiast!
All PMs will be ignored
--------------------------------------------------------------------------------------------------------
Highlighted
Moderator
Moderator
281 Views
Registered: ‎11-09-2015

HI @shixiaoke 

As mentioned by @dpaul24 , all the steps to generate the example design for the MIPI D-PHY IP are mentioned in the PG202


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post