Modifying IP properties

[dje666]

Dear Forum,

I need to force Vivado 2017.3 to pull in v3 of the HDMI IP as opposed to v2, which is the default.

http://www.wiki.xilinx.com/Xilinx+V4L2+hdmirx+driver#Related%20Links-Change%20Log

At the bottom of this page there is a note to say that Properties must be modified to pull-in v3 version of the IP's..

For any given project, where would I find the following IP properties so that I can edit them?

• Hdmi_rx_ss: C_HDMI_VERSION 3
• Vid_Phy: C_INT_HDMI_VER_CMPTBLE 3

Regards,

David

[florentw]

HI @dje666,

Quick question: Why not using a version of vivado which has the v3? It will (really) much easier and might avoid issues

[dje666]

Hi Florent,

Yes, switching to 2017.4 or later would be better, but I'm locked into 2017.3 right now, so instructions on how to proceed would be useful.

If I do make the move...... In your opinion which version of the Xilinx tools should I move to?

I need to ensure that I have board-support, BSP support PetaLinux support and driver support for HDMI IP in MPSoC-EV devices running on ZCU102 and ZCU106 dev-kits.

TTFN.

DJE666

[florentw · Accepted solution]

Hi @dje666,

I recommend you to move to 2018.1. The drivers are ready for HDMI. And of course the BSPs are already available for ZCU102 and ZCU106